Stops Mould Dead Clear
Features and benefits
EVO-STIK Stops Mould Dead Clear is an anti mould silicone for sealing joints in warm, humid environments prone to mould growth.
This clear, mould resistant sealant has a specialist, waterproof formula containing premium fungicides. It works by targeting mould at its source, penetrating deep into surfaces to effectively inhibit spores and their future growth.
Ready-to-use and easy-to-apply using a cartridge gun, Stops Mould Dead Clear can be used in a variety of applications to seal around tiles, baths, toilets, shower trays, basins, kitchen worktops and stainless-steel sink tops. Plus, it offers excellent adhesion to non-porous surfaces including glass, stainless steel, ceramic tiles and plastic baths and fittings.
Keep your home clean, healthy and free from mould and mildew with our best clear mould resistant silicone, that stays clear for life.
Suitable materials: Baths, toilets, shower trays, basins, work tops, tile joints and non-porous surfaces such as glass, stainless steel, ceramic tiles and plastic baths and fittings.
Sizes: 290ml
Coverage: Approx. 10 linear metres of 6mm diameter bead per 290ml cartridge.
HOW TO USE
1. EVO-STIK Stops Mould Dead Clear should be applied in warm but well-ventilated conditions. Joint surfaces must be clean, dry, sound and free from dust and other contaminants. If desired, masking tape can be used along the joint edge to help create a neat finish.
2. Unscrew the nozzle, cut off the dome of the cartridge and screw the nozzle back in place.
3. Cut off the tapered end of the nozzle at a 45° angle, to a width matching the gap to be sealed.
4. Insert the cartridge into the cartridge gun and once ready, squeeze the trigger until the sealant appears.
5. Place the nozzle at the start of the joint and gently squeeze the trigger. Push forward slowly along the joint, ensuring contact is made by the sealant with both sides of the gap. At the end of the run, release the trigger and press the plunger release plate of the gun.
6. Smooth the sealant with a wet, round ended tool (do not use a wetted finger). Remove any excess with a cloth moistened with white spirit and then remove the masking tape.
Drying time: The sealant skins over quickly (approx. 30-40 minutes) and is fully cured in approx. 1-2 days depending on bead width, temperature and humidity.
HOW TO REMOVE
Uncured sealant
The bulk should be removed carefully using a soft scraper. The remainder can be removed using a cloth just moistened with white spirit. Repeat using another clean cloth moistened with white spirit.
Cured sealant
There is no adequate solvent; carefully cut away excess with a very sharp knife. Do not use solvent to remove product from skin – use soap and water.
FAQS
Yes, EVO-STIK Stops Mould Dead contains premium fungicides to keep your seals looking brand new – it won’t stain, blacken or yellow. It works to target mould at the source, preventing mould and mildew growth that withstands the test of time and is available in both white and clear.
EVO-STIK Stops Mould Dead is our best mould resistant silicone sealant. It is important that once applied, the sealant is cleaned regularly and not submerged under water to continue working effectively.
