Rapid Set Floor & Wall Flexible Tile Adhesive

EVO-STIK Rapid Set Floor & Wall Flexible Tile Adhesive is a cement-based, grey flexible tile adhesive that will set in just two hours.
 

Colours

Grey

Sizes
20kg

Product overview

EVO-STIK Rapid Set Floor & Wall Flexible Tile Adhesive is a cement-based, grey flexible tile adhesive that will set in as little as two hours - ideal when you need a quick turnaround without compromising on durability.

Its flexible formulation allows it to cope with movement and vibration, making it suitable for wood floors and most domestic underfloor heating systems.

Waterproof and frost-resistant, this rapid set flexible tile adhesive performs brilliantly indoors and outdoors. Use it in bathrooms, kitchens and even external patios and steps. Plus, this fast set flexible tile adhesive supports both thin and thick bed applications (up to 12mm), giving you maximum versatility across a wide range of projects.

Suitable materials: The adhesive can be applied directly onto cured concrete and screeds, tile backer board, over tiles and onto wood flooring.

Suitable tiles: Ceramic, porcelain, natural stone, quarry, slate, granite, terrazzo and vinyl tiles.

Sizes: 20kg.

Coverage: 7m² per 20kg, dependent on the nature of the substrate, the adhesive bed thickness and the type of tile. 

Features & benefits

  • Cement-based rapid-set flexible tile adhesive

  • Grey flexible tile adhesive which takes foot traffic or can be grouted after two hours

  • Suitable for use on concrete, wood and plaster or plasterboard

  • Can be used with most domestic underfloor heating systems

  • Can be used for thin and thick bed applications to a maximum depth of 12mm

  • Waterproof and frost-resistant

  • Suitable for interior and exterior use

Downloads & resources

Rapid Set Floor & Wall Flexible Tile Adhesive - Technical Data Sheet (270.28 KB)

This file is stored on an external website, please follow the link

How to use

Preparation

1. Make sure walls and floors are clean, dry, flat, solid and free from dust, grease, paint or loose materials. Fill any cracks or holes. 

2. Check your substrate: 

  • Floors: New screeds should be 3 weeks old, new concrete 6 weeks. 
  • Walls: Ensure plaster or plasterboard can support the tile weight. Prime if needed.

3. Prime or prepare difficult surfaces:

  • Lightly abrade very smooth surfaces 
  • Prime dusty or very porous areas with a Bostik primer 

Application

1. Dry lay a few tiles to see how they fit and where cuts are needed. Cut tiles before mixing adhesive. Lightly mist the floor with water to help adhesion.

2. Gradually add the flexible tile adhesive to 4.4L of cold water. Mix until thick and creamy. Use within 30–40 minutes; don’t add more water later.

3. Spread adhesive with a notched trowel (minimum 3mm bed). Only spread about 1m2 at a time so it doesn't dry too quickly. Back-butter large tiles if needed.

4. Press tiles in with a slight twist. Lift one occasionally to check the back is fully covered. Use a spirit level to make sure the surface stays even and clean off any wet adhesive as you go.

5. Once tiles have set, approximately after 2 hours, grout the joints using EVO-STIK Rapid Set Floor Tile Grout or similar, by following the manufacturer's instructions. 

How to remove

1. Wipe away any extra adhesive from tiles or surfaces while it is still wet.

2. Clean your tools and equipment straight after use with warm, soapy water.

Dried adhesive? If the adhesive has dried, you will need to remove it mechanically - so it’s much easier to clean up right away! 

Find new, smarter ways of doing things

Find out what product you need, how to use it and where to buy it.

PRODUCT FINDER